The Influence Of Temperature On The Performance Of Industrial Electrostatic Precipitator For Polishing Machine Is Mainly Reflected In Several Aspects

The influence of temperature on the performance of Industrial Electrostatic Precipitator For Polishing Machine is mainly reflected in several aspects

To some extent, the non-polishing machine industrial electrostatic precipitator is more suitable for the dust removal of high temperature (high pressure) smoke than the polishing machine industrial electrostatic precipitator. In particular, compared with the latter, the length of the former charged area can be greatly reduced without reducing the efficiency of dust removal, thus reducing the volume of the equipment and reducing the cost. In other words, if the volume of the equipment remains unchanged, the former can greatly improve the capture efficiency of dust grains, especially fine dust particles. (charged voltage is 2500 v) temperature on the dust removal efficiency for no corona electric precipitator, the effect of temperature on the influence of the dust removal performance mainly embodied in the following several aspects: (1) raise the temperature, the thermal emission cathode current increases, the electron emission performance along with the change of temperature on the properties of no corona electric precipitator dust removal effect plays a main role, within the scope of the test temperature, viscosity of flue gas and dust particles than the resistance of the influence of the change on the polishing machine industrial electrostatic precipitator efficiency is not very significant; Increased pressure and the efficiency of dust removal declined slightly, mainly because the current density of the charge area decreased with the increase of pressure.

Industrial Electrostatic Precipitator For Polishing Machine The development of environmental protection industry because of its externality characteristic, the policy is the important force that promotes its development. 2013 at all levels of government have issued a series of fostering policy, environmental protection and energy saving industries since the launch to these policies and environmental pollution event catalytic, the rapid development of environmental protection and energy saving industry in 2013 is obvious to all. Environmental protection remains a hot topic during the two sessions. On the one hand, environmental issues are focused on the air, water and soil clean action plan. On the other hand, the conference focuses on environmental legislation, law enforcement and higher costs.

Industrial Electrostatic Precipitator For Polishing Machine Back in 2013, the green sector pulled out of the flagging market.Industrial Electrostatic Precipitator For Polishing Machine The overall performance of the environmental sector has been quite striking since the launch of the market on December 4, 2012. Statistics show, environmental protection plate phased rose more than 56%, environmental protection general patterns in the whole plate: atmospheric engineering sector rose 118.7% rose 73.7%, solid waste treatment, environmental monitoring plate plate rose 44.75%, water treatment engineering rose 58.8%, water operation plates are up 58.8%.

Industrial Electrostatic Precipitator For Polishing Machine The impact of the analysis policy on the environmental protection sector has been found to be closely related to the benefits of environmental protection. In August 2013, promulgated by the state council "about the opinions of the" speed up the development of energy saving and environmental protection industry, specifically the next three years development goals: energy conservation and environmental protection industry output value of average annual growth rate over 15%, to 2015, the output will reach 4.5 trillion yuan, become a new pillar industry of national economy.

Industrial Electrostatic Precipitator For Polishing Machine The illegal cost of industrial pollution in China is too low, and industrial pollution and waste disposal are far from reaching the standard. Therefore, the future industrial sewage, waste gas, solid waste disposal market still has a large space. In 2013, PENC was also more active in the environmental protection and energy saving industry. Water treatment, clean energy, solid waste treatment in three areas of investment amount above accounted for 80% of all investment projects, although most of these areas is not a new technology, but due to the most about people's livelihood, water, air, living environment of the regulation is imminent, coupled with the policy support and the demand of the natural, huge potential for investment in the environmental protection industry.