Industrial Electrostatic Precipitator Voltage Is Too Low Or No Power Failure Causes And Solutions

Industrial Electrostatic Precipitator voltage is too low or no power failure causes and solutions
Fault signs: When the engine to the normal speed drive Industrial Electrostatic Precipitator running, with the line of fire with the metal metal scissors without spark or spark bad.
   (1) cause of the malfunction:
    1, Industrial Electrostatic Precipitator drive belt (JYF a 60 type) or friction wheel pressing spring (JF a 30 type) too loose, resulting in Industrial Electrostatic Precipitator speed reduction.
    2, Fire wire leads or output wiring to damage, resulting in short circuit or open circuit.
    3, stator coil inter-turn short circuit or open circuit.
    4, permanent magnet rotor magnetic weakened or disappeared.
    (2) Exclusion method:
    1, adjust the belt tension or friction wheel compression pressure. For JYF-6 Industrial Electrostatic Precipitator, you can press the middle of the belt with your fingers, the belt drooping 10 to 20 mm for the better
    2, check the fire line leads or output terminals are damaged, there is the phenomenon of ground. If so, be excluded.
    3, with a test lamp or multimeter to check the stator coil insulation. Test lamp method: one end of the wire and Industrial Electrostatic Precipitator of a material out of the column connected to the other end of the connection bulb and a stylus, respectively, with the stylus contact with the chassis and ground terminal, according to the light bulb , You can determine the stator coil insulation: when the stylus contact with the case, if the light does not shine, the circuit is normal; if the light is on, then the circuit has ground phenomenon. When the stylus contacts the ground terminal, if the light is on, the circuit is normal; if the light does not light, the circuit has a circuit phenomenon.
Industrial Electrostatic Precipitator is not like the usual small commodity, the price is not cheap, we buy Industrial Electrostatic Precipitator after the hope that can be used for a long time and not within a period of time to buy another, so for industrial electrostatic dust The life expectancy is very high, how can we extend the life of our Industrial Electrostatic Precipitator?
 Industrial Electrostatic Precipitator life and the quality of their own Industrial Electrostatic Precipitator and our daily operating norms have a direct relationship between the Industrial Electrostatic Precipitator product quality is one aspect, in general, the quality of Industrial Electrostatic Precipitators are no problem, the main Or when we use the degree of operational norms, and after the use of the Notes. For the latter, Anhui Industrial Electrostatic Precipitator Xiao Bian summed up the following note:
    First, it is necessary to always adhere to the surface of Industrial Electrostatic Precipitator clean, clean the control panel when you pay attention to use a dry cloth or clean sponge for cleaning, so as not to penetrate the water into the board, burn the circuit board and electronic components.
    Second, every time after the use of Industrial Electrostatic Precipitator, please use a water pipe or spray gun to the sewage tank to clean the water, and all the waste away, so that you can adhere to the sewage tank cleaning, to avoid the accumulation of sludge or foreign matter blocked Sewage tanks, sewage tanks within the tennis also need regular cleaning.
    Third, the Industrial Electrostatic Precipitator clean water tank also need to protect and conservation, for a long time without the use of the case, you need to unplug the water pipe at the top, the water tank to the end of the water, to avoid water metamorphism, but also regular cleaning filter , If the ambient temperature is below 4 degrees Celsius, it is necessary to put the water in the water tank finished, otherwise it will cause the water temperature is too low and damage the motor, solenoid valve and pipeline.